NHTSA Recall Check

2012 Porsche 911 Turbo Recalls

NHTSA reports 2 open safety recalls for the 2012 Porsche 911 Turbo. All recall repairs are free at any authorized Porsche dealer, regardless of mileage or ownership.

Open Recalls for the 2012 Porsche 911 Turbo

20E091000Reported 11/12/2020

SUSPENSION:FRONT:MACPHERSON STRUT

Summary

Ohlins USA, Inc (Ohlins) is recalling certain Front Struts, part number POS 5N20. These struts were sold as part of Ohlins strut kits part number POZ MN02, intended for installation on 1999-2005 Porsche 911 Carrera 4 and 4S (generation 996), and 2001-2006 Porsche 911 Turbo / Turbo S (generation 996) and kit part number POZ MN05, intended for installation on 2005-2012 Porsche 911 Carrera 4 and 4S (generation 997), and 2006-2013 Porsche 911 Turbo / Turbo S (generation 997). The pin of the strut may experience excessive stress during maximum steering, possibly resulting breakage of the pin.

Consequence

If the pin fails, it will cause separation of the strut from the vehicle, affecting vehicle control and increasing the risk of a crash.

Remedy

Ohlins will notify owners, and dealers will request the return of all unsold kits containing the subject part from dealer/distributor inventory for a full refund. All owners who purchased one of the kits (POZ MN02 or POZ MN05) will receive replacement front struts (POS 5N20 or POS 5N21 - These parts are interchangeable), along with new top mount interface solutions, free of charge. The recall began December 22, 2020. Owners may contact Ohlins customer service at 1-800-336-9029.

Source: NHTSA campaign 20E091000 via nhtsa.gov/recalls

11V409000Reported 05/08/2011

SEAT BELTS

Summary

PORSCHE IS RECALLING CERTAIN MODEL YEAR 2011 911 SPEEDSTER AND 911 GTS RS 4.0; AND MODEL YEAR 2012 BOXSTER (INCLUDING S AND SPYDER); CAYMAN (INCLUDING S AND R); 911 CARRERA (INCLUDING S, GTS, 4, 4S, AND 4 GTS); 911 TARGA 4 AND TARGA 4S; AND 911 TURBO AND TURBO S MODELS MANUFACTURED FROM MAY 31, 2011, THROUGH JUNE 10, 2011. THERE IS A POSSIBILITY THAT THE MOUNTING HOLES IN THE SEAT BELT ANCHOR PLATES FITTED TO THE VEHICLE ARE TOO SMALL. IF THE HOLE DIAMETER IS TOO SMALL, THE ANCHOR PLATE MAY NOT BE ABLE TO ROTATE ABOUT THE FASTENING BOLT AS DESIGNED.

Consequence

SHOULD THIS OCCUR, THE SEAT BELT MAY NOT BE ROUTED OPTIMALLY AROUND THE OCCUPANT, OR MAY POTENTIALLY LOOSEN AT SOME POINT IN THE FUTURE INCREASING THE RISK OF INJURY DURING A CRASH.

Remedy

PORSCHE WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT THE SEAT BELT ANCHORS AND, IF NECESSARY, REPLACE THE SEAT BELT. THE REPAIRS WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON SEPTEMBER 2, 2011. OWNERS MAY CONTACT PORSCHE AT 1-800-767-7243.

Source: NHTSA campaign 11V409000 via nhtsa.gov/recalls

See 2012 Porsche 911 Turbo prices →

Verified buyer transactions, not estimates.

Porsche VIN decoder →

Decode any Porsche VIN free.

How to Get a Recall Repaired

  1. Confirm the recall applies to your specific Porsche 911 Turbo by checking the VIN above.
  2. Note the NHTSA campaign number from the recall details.
  3. Call any authorized Porsche dealer and reference the campaign number.
  4. Schedule the free repair. By federal law, the dealer must perform the recall remedy at no cost regardless of vehicle age or owner.
  5. Bring the vehicle to the appointment. Most recall repairs take 1-3 hours; some require parts to be ordered first.

Buying a 2012 Porsche 911 Turbo?

See what real buyers paid for this exact year and model on CarWhere — verified from actual deal sheets, not dealer ads.

Browse Porsche 911 Turbo Prices